|
A filter allows you to select the tests to include in a report.
A filter can be described in 3 ways:
By direct selection of the tests to be included.
By a simple logical condition entered graphically. In this case, all tests for which the logical condition is true are included in the report.
By a complex logical condition . In this case, all tests for which the logical condition is true are included in the report.
To create a filter:
You can choose to:
Open the protocol dialog box , select the " Report " tab , then click the button .png) in the filters column.
Select the "Reports" display mode, then click on .png) in the Filter panel of the command ribbon.
To modify a filter:
You can choose to:
Open the protocol dialog box , select the "Reports / Filters" tab, then click the button .png) in the filters column.
Select the "Reports" display mode,, then click on .png) in the Filter panel of the command ribbon.
To Copy a filter:
You can choose to:
Open the protocol dialog box , select the "Reports / Filters" tab, then click the button .png) in the filters column.
Select the "Reports" display mode, then click on .png) in the Filter panel of the command ribbon.
To remove a filter:
You can choose to:
Open the protocol dialog box , select the "Reports / Filters" tab, then click the button .png) in the filters column.
Select the "Reports" display mode, then click on .png) in the Filter panel of the command ribbon.
To filter items to include in a report:
Select a filter from the list of filters : .png)
|
